ich hab gerade mein JimStim V1.5 so angeschlossen damit ich das Tachsignal checken kann:
http://jbperf.com/JimStim/JimStim_v1_5_assembly.html
Es funktioniert alles, jedoch wenn ich das RPM FINE - Poti ganz langsam aufdrehe, kann es passieren dass die IAC2- LED sofort andauernd leuchtet (bzw. die Helligkeit leicht flackert). Drehe ich anschliesend ein bisschen weiter faengt die LED "ganz normal" langsam zu blinken an.Power off the JimStim and disconnect it from the MegaSquirt
Remove the pull up jumpers
Remove the primary tach jumper
Set the wheel mode to distributor mode (all DIP switches off)
Connect a wire jumper from the primary tach header (where the jumper usually goes) to an IAC led. Use the primary tach header pin closest to the pots (away from the PRIMARY TACH text) and the last pin of the 10-pin header (pin closest to the pots)
Connect a wire jumper from the other side of the IAC led to 12V. Use the next to last pin on the 10-pin header (just besides the pin connected in the previous step) and one of the pins on the 3-pin header besides the voltage regulator.
Turn the RPM pots all the way counterclockwise.
Habt ihr dieses "Problem" auch?
mfg
gruss